Knowledge - Xintai

Sep 30, 2022

Introduction to the excellent performance of PE sheet in gaskets

PE sheet and gasket features: non-toxic, tasteless, odorless, no independent air bubbles. Pearly, clean feel. Lightweight and full of cushioning elasticity. Has excellent chemical and oil resistance.

Oct 15, 2022

The advantages of PP polypropylene compared with PVC polyvinyl chloride

First of all, polypropylene sheet is an environmentally friendly material Second, the difference between polypropylene sheet and polyvinyl chloride; 1. Polypropylene sheets are hard to the touch, whil

Oct 30, 2022

The application and difference of PVC and PP sheet

PP sheet PP sheet (polypropylene) product features: impact resistance, corrosion resistance, high heat resistance, non-toxic and tasteless, smooth and beautiful surface, low density and light weight,

Nov 15, 2022

The performance of pp material

1. The pp material has very good physical and chemical properties. Its molding performance is very good, but due to the relatively large hand shrinkage of this material, it still cannot be produced fo

Nov 30, 2022

What plastic can withstand high temperature?

Generally it is PPS, LCP and high temperature nylon. 1. PPS is 260 degrees. 2. The high LCP is 300-350 degrees. 3. High temperature nylon is 260-290 degrees. Plastic products made of polyethylene, pol

Dec 15, 2022

What are the high temperature resistant plastic materials?

High temperature engineering plastics are a kind of plastics that can maintain their own high mechanical properties under high temperature conditions due to their special structure. Common high-temper

Dec 31, 2022

What are the components of pe board?

PE board is an indispensable material for cables and wires. This material has many formulas, mainly including the following components, generally AC foaming agent, ZnSt, LDPE and so on. Among these ma

Jan 15, 2023

Faults and solutions in the production process of PPH board

The punching method is the abbreviation of the punching and shearing method, that is, the pipe is cut off by a die on a press. This method is suitable for thin-walled pipes with relative pipe thicknes