Polyethylene board is used in many industries, but the correct use is very important. If it is used improperly, the polyethylene board cannot achieve the desired effect. At present, the processing of ultra-high molecular weight polyethylene sheets mainly adopts sintering molding method and plunger extrusion method, but the yield is very low.
UHMWPE sheet is very difficult to process due to the entanglement of UHMWPE of molecular chains, high viscosity and almost no fluidity. It is difficult to form products with ordinary processing equipment. Nylon sheet vehicle manufacturing and transportation industry: The main products are dump trucks, dump ship liners, and train vehicle crash parts. In order to allow you to use the polyethylene board correctly, the following editor will explain to you:
1. For the first time, the storage capacity of 2/3 of the whole warehouse in the warehouse is realized before unloading.
2. During the operation, the material loading and unloading points are always stacked in the warehouse inside the stack, and the storage capacity of the material is always kept within 1/2 of the warehouse.
3. It is strictly forbidden to directly affect the lining.
4. The hardness particles of different materials are different, and the material flow cannot be changed at will. When necessary, the material flow shall not be greater than 12% of the original design capacity.
5. The ambient temperature should not be higher than 80℃.
6. The structure and loose fasteners shall not be damaged by force.
7. The residence time of the material in the warehouse should not exceed 36 hours (the more viscous materials in the warehouse, please do not stay in the anti-caking water, the proportion should not exceed 4%). The rest time of the material can be appropriately increased.
8. When the temperature is low, please pay attention to the rest time of the materials in the warehouse to avoid freezing blocks.
