The surface of the PP plastic board should be clean. The consistent color and close seams, beautiful, and straight. The patterns and patterns at the joints are in line with no glue marks; they are closely connected to the wall, and the yin and yang horn are Zhengzheng.
Observe and check. The welding and welds of the sector should be flat, smooth, non -coordinating discoloration, spots, and peeling off the flying edge. Speak.
The size of the edge materials should be accurate, the corners are neat, the seams are tight, and the joints should be straight. The connection with the pipeline should be tight, firm, and flat. Observe and check with steel ruler. The skirting plate is closely connected to the PP plastic board.
At the same time, we must also meet customer requirements. Observe and check and check the qualification certificates and test reports. The bonding of the facial layer and the next layer should be firm. The varieties, specifications, colors, grades, and stickers of PP plastic plates and coils shall meet the requirements of design requirements and the current national specifications.
The appearance is flat, smooth, without wrinkles, not tilted, non -bubbles, no gum, no glue. Observe and check, use a small hammer to tap and check.
Note: The area of local dehydration should not be greater than 20cm, and the distance should not be less than 500mm. You can ignore the corner where the local dehydration is not covered. A single plate material and each natural room (specification room) do not exceed the total number of 5%. Essence
Each of the PP plastic board production process is important, including mixed, screw combination, temperature settings, host speed, feeding frequency, etc. If the production process changes at will, it will have an impact, such as spots, then how to prevent it?
1. Screw combination and temperature setting are two main influences.
For example, the screw for the production of PP plastic board must not have anti -threads. The temperature set by different machine settings of the same product may be large and normal. Do not easily change the process parameters after production. Balance may be destroyed, and spots are prone to occur.





